Revel's Adjustable Air Suspension Links replace the stock ride-height sensor links to lower your Ram 1500 while maintaining functionality of the truck's factory air suspension modes. The links utilize the factory ball studs for easy installation and require no alterations or cutting. Revel Links can also be easily removed at any time.
Pre-Adjusted Lowering Options
We offer two optional pre-adjustments for customers who would like their lowering links set before shipping:
Mild: Lowers the truck so that Normal ride height is approximately equivalent to the factory Entry/Exit height. This setting provides a noticeable drop while retaining more suspension travel than the Aggressive setting. Occasional contact with the factory bump stops may still occur depending on road conditions.
Aggressive: Provides a greater drop for customers looking for the lowest stance. At this setting, contact with the factory bump stops can occur over harsh dips or larger road irregularities. Trimming the bump stops approximately in half may reduce the frequency of contact, although contact may still occur under extreme suspension compression.
Compatibility
2019-2026 Ram 1500 with factory four-corner air suspension
Compatible with Ram Rebel and Rams equipped with the factory Off Road Package (ORP) when the goal is lowering the vehicle. The front spacer requirement discussed for these models applies when attempting to raise or level the front of the truck and is not required for lowering.
2019 Ram 1500 Classic: This model uses the previous-generation air suspension. Please select our 2016-2018 Ram 1500 lowering links.
How they work
Revel Links alter the signal from the Ram's factory ride-height sensors. For lowering, the front links are lengthened and the rear links are shortened. The truck's onboard computer detects a suspension position above the factory setting and adjusts the air suspension to compensate by lowering the vehicle. This allows the truck's ride height and front-to-rear stance to be adjusted while retaining the functionality of the factory air suspension system and its different ride modes.
How they are made
Revel Links are made from aluminum with a molded silicone coupler and are manufactured using CNC technology to achieve optimal performance and reliability.
Disclaimers
Lowering the vehicle reduces available suspension travel. The Mild and Aggressive pre-adjustments may result in a firmer ride compared with the factory ride height, and ride quality is subjective. If the ride is too firm or bump-stop contact occurs too frequently, the links can be readjusted according to our installation instructions to reduce the amount of lowering.
To provide the full available adjustment range, an initial amount of lowering may occur at the links' maximum setting. All ride-height measurements and adjustments should be based on the front of the vehicle.
Please read all instructions and contact our team with any questions prior to installation. If in doubt, please have your links installed by a licensed mechanic. Excessive lowering may affect the operation or availability of some factory air suspension modes and may produce air suspension system warnings. An alignment may be required after significantly altering the vehicle's ride height. Revel Performance or its suppliers will not be held liable for any loss or injury due to improper installation or adjustment.
Installation Instructions can be downloaded <here>
For Questions? Check out our FAQ
